Airturn DIGIT User Manual download pdf (Page 5)

Setup and Pairing

To use the BT-105 with your MAC, PC, or iPad, make sure the

host computer you are using is in discovery mode. (Check the

instructions that came with your computer or Bluetooth USB

dongle. For iPad users, go into “Settings”, then select

“Bluetooth” and make sure it is turned on). Turn on the BT-105

by pressing the red power button and holding for 1 second.

The LED will blink 3 times and attempt to pair with your

computer. Your host computer may require validation to accept

pairing from the BT-105. If it requires a code, use 0000. If you

are presented a code to validate the BT-105, accept it.

On the iPad, under the “Devices” heading within the Bluetooth

settings, you should see the BT-105 appear, either as a

keyboard, or as “AirTurn” with a serial number. Touch on top of

Serial Number to connect and complete the pairing process.

Once connected, it will blink green once every 2 seconds.

Resetting the Pairing

To reset the pairing on the BT-105, turn it on, wait 3 seconds,

press and hold the red button for 8 seconds until the LED

blinks a rapid series of green and red, then release. If pairing is

unsuccessful, delete the device displayed on the host

computer and reset the BT-105 pairing again. Initial discovery

may take up to 30 seconds (longer on some older PC and

MAC computers). To delete the BT-105 from the iPad’s

Bluetooth Device listing, tap the blue arrow button next to BT-

105’s serial number and connection status text (“Connected” or

“Not Connected”), then press the “Forget this Device” button.

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Airturn DIGIT User Manual Page 5